Front Panel - Everlast PowerARC 210ST Operator's Manual

Section 2
10.
11.
1. E6010 Stick function for welding with cellulose rods.
2. VRD function, when engaged, reduces Stick OCV for safe-
ty where required. <24V.
3. Selector toggles between parameters for adjustment.
4. Anti-Stick feature, when engaged, terminates welding
output when the welding rod sticks for easy rod removal
and safety. Helps eliminate arc flashing and flux damage.
5. Parameter control adjusts highlighted parameter values.
6. Mode selector selects between Stick or TIG welding
modes. Indicated by Stick or TIG torch.
7. Start mode offers the user a choice of TIG arc start type:
Lift Start (with remote) or Live Lift (no switch or pedal
with live Tungsten).
8. Remote function chooses how the unit operates with the
remote (pedal or 2T/4T torch switch operation).
9. Display/LEDs indicate function value (#3) and value being
adjusted. Values indicated: Hertz (Hz), Seconds (S), Per-
cent (%), Amps (A), Error/Warning, ON Status.
10. The Positive Terminal (DINSE 25 type) is used to connect
the Stick electrode holder in Stick mode. In TIG mode
PowerARC 210STL
Front Panel View
STICK
6010
1.
AMPS
VRD
2.
ANTI
STICK
3.
4.
5.
GAS OUTLET
General Setup and Operation
IMPORTANT! READ OPERATOR'S MANUAL BEFORE USE!
ON %
8.8.8.
2T
S
!
A
TIG
POST FLOW
HOT START HOT START
STICK TIG
LIVE
INTENSITY TIME ARC FORCE
DOWNSLOPE
LIFT
EVERLAST
PowerARC 210STL
CONTROL
the work clamp is connected here.
11. The Shielding Gas Quick Connect Coupling is used to con-
nect the gas line from the DINSE 25 type TIG torch con-
nector. When the gas line is fully inserted into coupling,
the coupling collar automatically slides forward and
locks gas line coupler in place. To remove the gas line,
slide outer collar back and the gas line side of the cou-
pler will release.
12. The Control Terminal Connection is used for controlling
amperage and arc starting during TIG welding activities.
The coupler can be used with the optional NOVA foot
pedal, or included torch switch. In addition, it can be
used in conjunction with the optional torch mounted
Amp slider switch. When "Live Lift" is selected, this con-
nection is not used. Make sure this connector is fully
tightened by hand. Do not leave loose.
13. The Negative Terminal (DINSE 25 type) is used to con-
nect to the TIG torch in TIG mode. In Stick mode, the
work clamp is connected here Note: This connector is
not a gas-through type DINSE connector. See #10.
15
TIG 9.
4T
PEDAL
8.
HF
LIFT
START
START
7.
6.
12.
13.