Sanyo PLV-Z2000 Owner's Manual page 42

Setting
Test pattern
A test pattern for zoom and focus adjustment is available for use
when setting up the projector.
Filter counter
This function is used to set a frequency for the filter cleaning.
When the projector reached a specified time between cleanings, a
Filter warning icon appears on the screen, notifying the cleaning is
necessary.
Use the Point button to select the desired timer [Off/ 50H/ 100H/
200H/ 300H/ 400H/ 500H] and press the OK button. After cleaning
the filter, be sure to select [Reset] and set the timer. The Filter
warning icon will not turn off until the filter counter is reset.
For details about resetting the timer, refer to "Resetting the Filter
Counter" on page 48.
Cleaning
This function is used to clean the inside of the projector. Using a
blower at the same time is more effective. See page 46.
Press the Point or OK buttons, then the projected image is
blacked out temporarily regardless of whether or not an input
source is selected.
To cancel the cleaning function, set the projector back into
the right position, then press any other button during cleaning
operations.
Note:
• The Power management function cannot be operated during
cleaning.
Highland
When using the projector in high altitudes (about 1,200 meters or
more above the sea level), set this function "On. " Press the Point
or OK buttons to switch On/Off.
Lamp counter reset
This function resets the lamp replacement counter. When
replacing the projection lamp, reset the lamp replacement counter
with this function. See page 50 for operation.
Service port
For techinician use ONLY. Set this function to Off.
Factory default
This function restores all setting values except for the user's logo,
the filter counter and the lamp time to the factory default settings.
42
Filter counter
Use the Point
the timer from (Reset/Off/
50H/ 100H/ 200H/ 300H/ 400H/
500H) depending on the use
environment.
Filter warning icon appears on the screen at a set
time.
Note:
• The Filter warning icon will not appear when
the Display function is set to "Off" (p.40), during
"Freeze" (p.23), or "No show" (p.23).
Factory default
Select Factory default and
press the OK or Point
buttons. "Return to Factory
default?" appears.
Select [Yes] and press the
OK button, then another
confirmation box appears.
Select [Yes] again to
restore to the factory
default settings.
button to select