Basic Operation; Turning On The Projector - Sanyo PLV-Z2000 Owner's Manual

Basic Operation

Turning On the Projector

Complete peripheral connections (with a computer, VCR,
1
etc.) before turning on the projector.
Connect the projector's AC power cord into an AC outlet and
2
turn the Main On/Off switch on. The POWER indicator lights
red.
Press the POWER ON/STAND-BY button on the top control or
3
on the remote control.
The POWER indicator turns green and the cooling fans start to
operate. As the automatic slide shutter opens, a preparation
display appears on the screen and the countdown starts.
After the countdown, the input source that was selected the
4
last time appears on the screen.
Note:
• If the automatic slide shutter does not open properly, the projector
will not be turned on and the POWER indicator will blink orange.
Press the POWER ON/STAND-BY button again to restart.
• When "Countdown off" or "Off" is selected in the Display function,
the countdown will not be displayed on the screen (p.40).
• During the countdown period, all operations are invalid.
• Image may look dark for a while after turning on the projector.
Lamp needs some time to stabilize after the power is turned on.
Stored lamp mode and the image mode will be active after the
lamp is stabilized.
18
POWER
POWER indicator
ON/STAND-BY
button
Top Control Remote Control
Main On/Off switch
OFF ON
Selected Input Source
Use this tab when handling manually.
Automatic Slide Shutter
Do not touch the slide shutter while it is
moving, as this could cause injury or the
projector to malfunction.