Image Adjustment; Image Mode Adjustment - Sanyo PLV-Z2000 Owner's Manual

Image Adjustment

Image Mode Adjustment

Image mode can be adjusted for each input source and the adjustment is kept until the projector is turned off or the image
mode is changed.
Direct Operation
Press the IMAGE ADJ. button on the remote control to display
the adjustment bar of Image adj. Menu items one at a time and
directly adjust the selected item.
Use the Point buttons to select the desired item and the Point
buttons to adjust the setting. Press the MENU button after
adjusting.
If you press the OK button after adjusting each item, it will enter
the main menu.
Menu Operation
Press the Point
1
and press the Point
items.
Use the Point
2
press the Point
The adjustment bar is displayed.
Use the Point
3
press the OK button.
Brightness
Press the Point button to decrease the brightness; press the
Point button to increase the brightness (from -31 to +31).
Contrast
Press the Point button to decrease the contrast; press the Point
button to increase the contrast (from -31 to +31).
Color
Press the Point button to decrease the intensity of the color;
press the Point button to increase the intensity of the color
(from -31 to +31).
Tint
Use the Point buttons to adjust the tint value to obtain a
proper color balance (from -31 to +31).
Color temp.
Use the Point buttons to select the desired Color temp. level
(High2, High1, Default, Low1, or Low2). Default is based on the
currently set image mode (p.27).
Notes:
• Tint cannot be selected when the video system is PAL, SECAM,
PAL-M, or PAL-N in Video input or S-video input.
• The Image adj. Menu cannot be operated without an input signal.
28
buttons to select the Image adj. Menu
or OK buttons to access the submenu
buttons to select the desired item and
or OK buttons to access the selected item.
buttons to adjust the setting values and
Remote Control
When Advanced menu is set to Off.
Brightness Contrast Color
temp. Red Green Blue
Lamp control Gamma Progressive
reduction Brightness
• • • •
When Advanced menu is set to On.
Brightness Contrast Color
temp. Red Green Blue
Lamp control Gamma Progressive
reduction Iris mode Iris range
stretch Contrast enhancement
improvement Color management
Dynamic gamma 3D-Y/C
Brightness
• • • •
Note:
• 3D-Y/C may not appear depending on the input
signal.
Image adj. Menu
Notes:
• Above image is an example of when the Image
mode is set to "Natural. " Each value varies
depending on the selected Image mode (p.27).
Go on to the next page....
IMAGE ADJ. button
Tint Color
Sharpness
Noise
Tint Color
Sharpness
Noise
Auto black
Transient
Color list
Custom gamma