Computer Input; Input Source Selection - Sanyo PLC-XW65K Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Choose either RGB or Computer 2 by pressing the
COMPUTER button on the remote control. Before using
COMPUTER button, correct input source should be
selected through Menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Press the Point
framed pointer to the Input Menu icon.
2
Press the Point ed
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
✔
Notes:
• When the Input Search function is set On1 or On2,
the input signal will be searched automatically (p.46)
• Computer 2 is not displayed when the COMPUTER
IN 2/MONITOR OUT terminal is set as Monitor out.
(p.50)
• Computer 2 (COMPUTER IN 2 / MONITOR OUT) can
accept only RGB signal.
6
7 8 buttons to move the red
buttons to move the red arrow
Remote Control
COMPUTER button
RGB
Computer 
✳
✳ See Notes at the bottom of this page.
✳
Input Menu icon
Input Menu
M ove t h e p o i n t e r ( r e d
arrow) to Computer 1 and
press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
M ove t h e p o i n t e r ( r e d
arrow) to Computer 2 and
press the SELECT button.
COMPUTER button