Basic Operation; Turning On The Projector - Sanyo PLC-XW65K Owner's Manual

Basic Operation

Turning On the Projector

1
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
2
Connect the projector's AC power cord into an AC
outlet. The POWER indicator becomes red. Open the
lens cover.
3
Press the POWER ON/STAND-BY button on the
top control or on the remote control. The POWER
indicator becomes green and the cooling fans start
to operate. The preparation display appears on the
screen and the count down starts.
4
After the countdown, the input source that was
selected the last time and the Lamp mode status icon
(see page 52) appears on the screen.
5
If there is no signal input when start on the projector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point
and press the SELECT button. And then follow the
input signal guidance window to correct the signal and
connection.
If the projector is locked with a PIN code, PIN code
Input Dialog Box appears. Enter the PIN code as
instructed on the next page.
✔
Notes:
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.46)
• When the Logo select function is off, the logo is not
shown on the screen. (p.48)
• When the "Countdown off" or "Off" is selected in the
Display function, the countdown is not shown on the
screen. (p.48)
• During the countdown period, all operations are
invalid.
• When the "Off" is selected in the Display function,
the Video/PC selection window and the input signal
guidance window are not shown on the screen. (p.48)
18
The preparation display disappears after 30
seconds.
Selected Input Source and Lamp Mode
(See page 52 for Lamp mode.)
Video / PC selection window
buttons
ed
Input signal guidance window
Current Input setting:Video
Is signal processed correctly?
Is cable connected properly?
Video / PC selection window
Input signal guidance window
Current Input setting:RGB
Is signal processed correctly?
Is cable connected properly?
16
Lamp mode
No signal
No signal