Sanyo PLC-XW65K Owner's Manual page 51

Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not used for a certain
period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display with
"No signal" appears. The countdown starts to turn off the
lamp.
Select one of the operations:
Ready. . . . . . . . When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button
on the top control or remote control is
pressed.
Shut down . . . . When the lamp has been fully cooled
down, the power is turned off.
Off . . . . . . . . . . Power management function is off.
Then set the countdown timer with the Point
✔
Note:
Factory default is " Ready, 5 min".
On start
When this function is "On", the projector is automatically
turned on just by connecting the AC power cord to a wall
outlet.
✔
Note:
Be sure to turn the projector off properly (see "Turning
Off the Projector" on page 20). If the projector is
turned off in the incorrect sequence, the On start
function does not operate properly.
Power management
Time left before Lamp is off.
buttons.
On start
Setting
Press the SELECT button
at Power management and
this box appears. Choose
one of three settings with
the Point buttons, and
go to the timer with the
Point buttons and set
time with the Point
buttons.
51