Transfer From Bed To Carevo - Arjohuntleigh Carevo Instructions For Use Manual

Transfer from Bed to Carevo

Fig. 1
Fig. 2
Fig. 3
Lateral Transfer (21 Steps)
(For lateral transfers always use a sliding aid. For sliding aid
instructions, see respective sliding aid IFU.)
1 Fold down the Carevo side support on the transfer side and
lower the adjustable back support, if available.
2 Apply the brakes on the bed.
3 Adjust the bed to an ergonomic height.
4 Place the sliding aid (tube/sheet) under the patient.
(Use local technique) (See Fig. 1)
5 Place a pillow under the patient's head.
6 Fold down the bed rail on the transfer side.
7 Position the Carevo next to the bed's transfer side.
8 Fold down the Carevo mattress on the transfer side. Press
down and fixate the Carevo mattress corners between the
head/foot panel and support plate. (See Fig. 2)
9 Adjust the Carevo height so that its slightly lower than the
bed. (See Fig. 3)
NOTE
If there is a gap between the bed and Carevo, place
a sliding board in between the two to bridge the
gap.
10
WARNING
To avoid the device in use from tipping, do not
raise or lower other equipment close to it and be
aware of stationary object when lowering.
Push the Carevo against the bed
continue with the steps on the next page
18