Connections - Sanyo SRT-2400DC Instruction Manual

NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001

CONNECTIONS

Connect the video camera and monitor TV as shown in the figure below.
NOTE:
Before making the connections, make sure all the devices are disconnected from the DC power supply.
PUSH
OPEN
To DC power supply
About the memory reset
If the VCR location is changed or to cancel previous
settings, please reset the memory as described below.
The time and date will be reset, and the security lock will
be cancelled.
To reset the memory, press the ALL RESET button.
NOTES:
For more details, please refer to the manuals
accompanying all other devices. If the connections are
not made properly, it may cause a fire or damage the
equipment.
You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
If there is no video signal when the power is turned on,
"NO VIDEO" will be displayed on-screen.
Video camera
(sold separately)
From an external
audio source
ALARM OUT/ ALARM IN/ SERIES OUT/ SERIES SW
CLOCK OUT CLOCK IN COM NON REC OUT IN OUT
WARNING TAPE
OUT END OUT COM COM
DC12V IN
AUDIO
IN
REMOTE MIC IN
OUT
To remote
control
(sold separately)
8
Monitor TV (sold separately)
To
VIDEO IN
jack
EJECT
OUT IN
VIDEO
IN
OUT
To
VIDEO OUT
jack
Coaxial cable
(sold separately)
Use a DC power cord rated A.W.G 18 (1.25 mm
more.
The table below indicates the DC power source output
and DC power maximum cord lengths.
DC power source output DC power maximum cord
16 V 3 A
14 V 3.5 A
12 V 4.5 A
10 V 7 A
10 V 5 A
2
) or
lengths
6 m
6 m
6 m
6 m
2 m
English