Connections - Sanyo SRT-612DC Instruction Manual

CONNECTIONS

Connect the video camera and monitor TV as shown in the figure below.
NOTE:
Before making the connections, make sure all the devices are disconnected from the DC power supply.
About the memory reset
If the VCR location is changed or to cancel previous
settings, please reset the memory as described below.
The timer and date will be reset.
To reset the memory, press the ALL RESET button.
Video camera
(sold separately)
From an external
audio source
DC12V IN
PUSH
OPEN
DC power cord
(not supplied)
To DC power supply
To
VIDEO IN
terminal
EXT WARNING TAPE SW ALARM
TIMER IN COM OUT END OUT OUT COM OUT IN
AUDIO VIDEO
IN
IN
OUT
REMOTE MIC IN
OUT
To
VIDEO OUT
terminal
Coaxial cable
(sold separately)
NOTES:
•
For more details, please refer to the manuals
accompanying all other devices. If the connections are
not made properly, it may cause a fire or damage the
equipment.
•
Use a DC power cord rated A.W.G 16 or more, of a
maximum length of 6 m.
•
The DC power supply source should be able to supply
8 A or more. If the power supply is not sufficient, the
VCR may not operate properly.
7
Monitor TV (sold separately)