Remote Jack - Sanyo SRT-2400DC Instruction Manual

NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001
OUTPUT TERMINALS

REMOTE Jack

You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
NOTE:
The functions not available on the VCR will not operate.
Remote control of the VCR is possible by connecting a
remote controller with a circuit such as indicated below, to
the REMOTE jack.
NOTES:
Use a 3.5 mm mini-jack type plug.
The connection should be done using a shielded cable
no more than 5 meters long.
The functions not available on the VCR will not operate.
Remote control circuit
R0 1.2K
SW0: EJECT
R1 0.3K
SW1: STOP
R2 0.43K
SW2: PAUSE/SEARCH
R3 0.51K
SW3: REW
R4 0.62K
SW4: FF
R5 0.75K
SW5: PLAY
R6 0.91K
SW6: REC
R7 1.1K
SW7: EJECT (or MENU)
R8 1.3K
SW8: Do not use
R9 2.0K
SW9: TIMER, j
R10 2.4K
SW10: REC/PLAY SPEED CHANGE, l
R11 3.6K
SW11: TRACKING V.STILL – , ]
R12 5.6K
SW12: TRACKING V.STILL +, «
The resistance tolerance is
2% or less.
Remote control setting
The remote control switch 7 can be set to either eject the
tape or access the menus.
1
Press the MENU button until the (SET UP 5) menu is
displayed.
@@@@@@@<SET@UP@5>
*INPUT@OUTPUT@ALARM
*OUTPUT@@@@@@@SERIES
*WARN.@OUT@@@@TRANSPORT
*REMOTE@@@@@@@EJECT
*TAPE@@@@@@@@@T-160
2
Press the ] button, until the "REMOTE" setting is
flashing.
3
Press the l (or j) button to select the desired switch
mode.
EJECT . . . . . . Switch 7 will eject the tape.
MENU. . . . . . . Switch 7 will display the menu.
4
Press the PAUSE/SEARCH button to save the setting.
COM Terminal
Common GND (ground) terminal when connecting
other terminals to external devices.
42
English