Table of Contents
Advertisement
2
PREPARATION
@$ AV connection
We recommend that you use an
AV-cable (sold separately) as
indicated, You can get a higher
quality of picture and sound
during playback.
5
CONNECTIONS
1
2
Disconnect the antenna lead from the TV
antenna terminal.
Antenna
'7-
Make connections
0 to@ shown in the
illustration.
Antenna
L4N-R
@@@@
1.
To a wall socket
(4]~
Power cord
IT
Hi-Fi audio connection
If the TV is monaural, connect an AV-cable to
a stereo sound system to enjoy Hi-Fi sound.
And you can obtain a dynamic sound output
through your Hi-Fi system when you playback
a tape recorded in Hi-Fi stereo on this VCR.
Stereo audio system
Audio-cable
(IIOt
SUDDlif3d)
I
Switching the VCR power on/standby
Power is switched onloff by pressing the 0/1
button on the remote control or on the VCR.
VCR display
Standby mode (O)
Only the clock is displayed.
Power on mode(1)
The clock and the programme
position are
displayed.
Saving energy (ECO mode)
The ECO mode reduces the electricity
consumption
by turning off the VCR display
and other components
while the VCR is in
standby mode.
To set the ECO mode
1
Press the 0/1 button to turn the VCR
standby mode.
2
Press and hold the 0/1 button for more than
3 seconds.
The 0/1 button (ENERGY SAVER)
comes green. And nothing is displayed
on the VCR display.
-m
To cancel the ECO mode
Press the 0/1 button to turn the VCR on.
A
When a timer recording is programmed,
the
ECO mode cannot be set.
When watching TV, do not set the ECO
mode. If the ECO mode is set, the aerial
output from the VCR will deteriorate giving
very poor TV reception.
Advertisement
Table of Contents
