Connections - Sanyo TSL-4024P Instruction Manual

NK4QG/EX (TLS-4024P GB) Tue. Sept., 10/2002

CONNECTIONS

Connect the video camera and TV monitor as shown in the figure below.
NOTE:
Before making the connections, make sure the devices are disconnected from the power outlet.
PUSH
OPEN
To DC power supply
NOTES:
œ For more details, please refer to the manuals
accompanying all other devices. If the connections
are not made properly, it may cause a fire or damage
the equipment.
œ You can use a VA-RMN01 Remote Control Unit (sold
separately) to control the VCR remotely.
œ If there is no video signal when the power is turned
on, "NO VIDEO" will be displayed on-screen.
Video camera
(sold separately)
From an external
audio source
OPEN COLLECTOR
1=500mA(Max.)
2= 50mA(Max.)
3=SEE MANUAL CONTROL IN 3 EXT TIMER WARNING OUT 1
(ALARM RESET) IN
ALARM(1 SHOT)IN SERIES IN 3 COM CONTROL OUT 3
DC 12-24V IN
AUDIO
IN
REMOTE
OUT
DC power cord
(not supplied)
To remote control
(sold separately)
œ Use a DC power cord rated A.W.G 18 (1.25 mm
œ The table below indicates the DC power source output
DC power source output
8
TV Monitor (sold separately)
To
VIDEO
IN
jack
TAPE END OUT 2 SW OUT
TIMER OUT 3
VIDEO
IN
OUT
Coaxial
cable
(sold
To
separately)
VIDEO
OUT
jack
more.
and DC power maximum cord lengths.
DC power maximum
18 V or more 2 A
12 ~ 16 V 3 A
2
) or
cord lengths
6 m
6 m
English