Normal Playback - Sanyo SRT-2400DC Instruction Manual

NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001

NORMAL PLAYBACK

Normal Playback
1
Turn on the power to the VCR and TV monitor.
2
Load the video cassette tape.
3
Press the REC/PLAY SPEED CHANGE button to
select the playback speed mode.
° The selected playback speed mode is displayed
on the digital display.
NOTE:
A slow motion effect or accelerated playback effect
can be achieved by using a slower or faster
playback speed than the speed used for recording.
4
Press the PLAY button.
° Playback starts.
° If necessary, adjust the tracking to eliminate the
noise from the picture.
° If the image is unstable (rolling vertically), adjust
the vertical lock control to correct.
5
To stop playback, press the STOP button.
° To advance or rewind the tape, press the FF or
REW button.
NOTES:
If a tape recorded in SP mode on a standard VCR is
loaded, playback will be done in 2-hour mode.
A tape recorded on a real time video recorder produced
by another manufacturer may not play back with the
same degree of clarity on this unit.
When used with a multiplexer in 24- or 40-hour mode
playback (or when "TAPE" in (SET UP 5) menu is set to
"T-120", in 18- or 30-hour mode playback), the image
may roll vertically. In such a case, in menu (SET UP 3)
set "VERTICAL SYNC." to "N".
English
Tracking Control
If there is noise in the image during playback,
1
While looking at the playback picture, press and hold
the TRACKING/V. STILL+ button to minimize the
noise.
2
If it cannot be minimized, press the TRACKING/V.
STILL– button.
Vertical Lock Control
During still image mode,
1
Press and hold the TRACKING/V. STILL+ button to
reduce the vertical rolling of the image.
2
If it cannot be corrected, press the TRACKING/V.
STILL– button.
Audio Playback
The playback speed has to be the same as the
recording speed, for normal playback of the audio.
33