Sanyo SRT-2400DC Instruction Manual page 33

NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001
SERIES RECORDING
Continous Loop Recording Setup
A minimum of 2 units are required for continuous loop
recording.
Example with 2 VCRs.
Under loop recording when the recording finishes on the
first unit, the new recording will start on the second unit.
When the recording finishes on the second unit, recording
will start on the first unit.
1
The SERIES OUT/CLOCK OUT terminal of VCR
No.2 and the SERIES IN terminal No.1 should be
connected (See diagram).
2
Set the following items as indicated.
Item VCR No.1
Cassette tape
Operation mode
"TAPE END MODE" (in
(SET UP 3) menu)
"SERIES REC IN" (in
(SET UP 3) menu)
"OUTPUT" (in (SET UP
5) menu)
Security lock Canceled
3
Press the REC button on VCR No.1.
° Recording will start in series recording mode.
4
Set the security lock on VCR No.1.
Loop recording connection (example with 2 VCRs)
Video camera
VCR No.1
DC12V IN
VCR No.2
Loaded Loaded
Stop Stop
REW REW
Y (YES) Y (YES)
SERIES SERIES
Set
To
VIDEO IN
jack
ALARM OUT/ ALARM IN/ SERIES OUT/ SERIES SW EJECT
CLOCK OUT CLOCK IN COM NON REC OUT IN OUT OUT IN
WARNING TAPE
OUT END OUT COM COM
To COM
terminal
To
VIDEO OUT
To
jack
SERIES OUT
terminal
To
SERIES IN
terminal
32
NOTES:
To avoid recording problems, the "TAPE END MODE"
in (SET UP 3) menu should be set to "REW" for both
units.
In loop recording mode, the tape will be re-recorded
over. If you need to keep the recorded infomation,
please eject the tape after recording is complete and
insert a new tape.
Monitor TV
To
VIDEO IN
VCR No.2 jack
ALARM OUT/ ALARM IN/ SERIES OUT/ SERIES SW EJECT
CLOCK OUT CLOCK IN COM NON REC OUT IN OUT OUT IN
WARNING TAPE
OUT END OUT COM COM
DC12V IN
To
VIDEO OUT
To COM
jack
terminal
To
SERIES OUT
terminal
To
SERIES IN
terminal
English