Antenna To Vcr Connections - Sanyo VWM-700 Instruction Manual

ANTENNA TO VCR CONNECTIONS
Maril~~-.a
. . .
mtF Antenna VHF Antenna VHF/UHF Antenna VHF/UHF Antenna
300 ohm 75 ohm
Twin-Lead Coaxial
Cable
,---•L-- ---"----,
Cable
VHF/UHF mixer
(Not supplied)
AR
C IN OUT
OR
75ohm
Coaxial
Cable
3oons ohm
Adaptor
(Not supplied)
----- -------·--··-·-···;
~ @-@L
~
VHF/UHF
~iP :.: O
VCR's Back Panel
1
Disconnect the antenna leads from the rear of the TV receiver.
'
.
300ohm
twin lead
2
Identify the type of cable from your antenna. If it is a round cable as illustrated, it is a
75 ohm coaxial antenna cable. This cable will connect directly to the connector marked
ANT.IN on your VCR.
If your antenna lead wire is a flat type antenna cable, connect it to a Antenna Adaptor
(300-ohm to 75-ohm) (not supplied) and slip the Adaptor onto the ANT. IN connector. The
Adaptor does not screw on to the VCR, it just slips over the connector.
7