Advertisement
Installation Instructions
Local Unit
(Transmitter)
Notes:
• If using the EDID copy feature, perform the procedure from the EDID Copy
section of this manual prior to installation. If you are not using the EDID copy
feature, the transmitter will use a default set of EDID information.
• The diagram above shows a B130-202 installation. The B130-202A installation
will be the same, except for the addition of audio connections.
• Test to make sure that the entire installation works properly prior to pulling cables
through ceilings/walls.
• To achieve maximum distance and performance, 24AWG solid wire Cat5e/6 cable
must be used. The use of stranded wire Cat5e/6 cable, or cable with a gauge
(AWG) size higher than 24AWG, will result in shorter extension distance.
All Tripp Lite N202-Series Cat6 cables are made with 24AWG solid wire.
Tripp Lite's N022-01K-GY (Cat5e) and N222-01K-GY (Cat6) are 24AWG solid
wire bulk cables. For optimal image quality, use Zero-Skew cable, such as
Tripp Lite's P524-01K.
• To achieve maximum resolution, it is recommended that you use Tripp Lite
P502-Series VGA video or P504-Series VGA video and audio* cables with
RGB coax.
14-11-117-93-333B.indd 6
3
4
2
Source
Remote Unit
(Receiver)
7
UP TO 500 ft. (150 m)
5
6
6
Source
11/24/2014 2:51:42 PM
Advertisement
