Advertisement
Thoroughly remove excessive Sika after
riveting by using a particular Sika remov-
ing agent and seal then the cutting
edges. Now, any fixtures used can be
removed, too.
Rivet the fixing plates (article no.
111978) laterally below the cut reinforc-
ing clips (see page 5 / image in the mid-
dle). The plates for which boreholes
have already been prepared must only
by aligned centrally to the reinforcing clip
and the drilling template must be trans-
ferred to the car body and the reinforcing
frame, bore diameter 5 mm, rivets with
4.8 x 16.9 mm aluminium/steel. The ve-
hicles with a short wheel base (SCA
194/195) have four fixing plates on the
left side, three plates on the right side
due to the sliding door..
5. Sleeping Roof Assembly
Position the assembled sleeping roof
(condition at the time of delivery) onto
the vehicle and open the roof. Support
the roof shell in front. After that, align the
spoiler of the platform with the contours
of the windscreen as well as with the
lateral drip rail. Now, the sleeping roof
must be secured against shifting. Please
pay attention to fasten the screw clamps
in a way to prevent a collision with the
roof shell when closing the roof. Finally,
check the roof for proper functioning.
Stand: März 2013
Achtung: der Kabelstrang mit den Befestigungsble-
che fixieren (siehe Bild).
C.F. Maier Europlast GmbH & Co KG
Seite 9 von 16
Advertisement
