6. Assembly of Interlocking
Insert the provided interlocking sheets into the
slotted holes and mark the holes.
Bore two holes with 5mm and then tap M6.
Put Interlocking into dedicated notch and fit
it with delivered Screw (M6x16)
Close the roof and adjust the interlocking
by moving it to the top or bottom to achieve
that the upper interlocking engages into the
lower interlocking without exerting pres-
sure. Finally, you can tighten the screws..
Stand: März 2013
C.F. Maier Europlast GmbH & Co KG
Seite 14 von 16