Table of Contents
Advertisement
CHARGING THE BATTERY PACK
1.
Start with the AC Cable. Connect it to the AC - DC Adaptor.
The AC Cable is Universal to NEMA 5-15P , 3 prong for USA and will
work with a power range of 100VAC–240VAC 50/60 Hz.
2.
Then, plug the Barrel Connector (part of the AC-DC Adaptor) into the
Charging Port of the Nomad
Input voltage: 11–17VDC. Do NOT exceed!
The Nomad
before using it for the first time.
When the Charge Indicator FLASHES green it indicates that the
Battery Pack is being charged. When the Nomad
charged, the Charge Indicator will turn solid green.
Charging time will be approximately 4 hours.
CHARGING FROM A 12VDC VEHICLE ADAPTOR
1.
Insert the 12VDC Vehicle Adaptor into a 12V socket (located within the
vehicle).
2.
Then, insert the opposite end (Barrel Connector) into the Charging Port of
the Nomad
.
®
NOTE: Do NOT start vehicle while the Nomad
while plugged in.
CHARGE INDICATOR
COLOR
GREEN (SOLID)
GREEN (FLASHING)
RED (SOLID)
*If a charging error occurs, please contact FoxFury Customer Service (see pg. 16).
NOTE: Continuously charging (leaving the unit plugged in) could damage the
Battery Pack and lead to a decreased battery life. Please disconnect the unit
once it is fully charged.
Please DO NOT leave AC-DC Adaptor plugged in for more than eight (8)
continuous hours.
.
®
is shipped with a 30% charge. It is important to charge it
®
(FOR LOCATION, PLEASE REFERENCE PAGE 3)
DESCRIPTION
FULL Y CHARGED
CHARGING
CHARGING ERROR
is completely
®
is being charged or when using
®
5
Advertisement
Table of Contents
