Table of Contents
Advertisement
MAINTENANCE
REMOVING THE BATTERY PACK | 4 MINS
At the end of the Battery Packs's life (which is about 500+ full charges), the
Battery Pack will stop holding a charge and will need replacing.
1
3
Make sure the Nomad
1.
1
Begin with the back of the Nomad
screws on the rear panel.
2.
2
Use a Phillips Head (+) #1 screwdriver to unscrew and remove the eight (8)
screws. Then, remove the rear panel.
3.
3
Once the rear panel is removed, notice a black strap, which holds the
Battery Pack in place. There is one (1) screw on each side of the strap.
Remove both using the same Phillips Head screwdriver. This will then
release the Battery Pack strap.
4.
Pull the Battery Pack out of the Nomad
4
light by unclipping the Connector.
12
is turned OFF before starting.
®
®
2
4
facing you. Locate the eight (8)
Body . Then, detach it from the
®
(APPROX)
CONNECTOR
Advertisement
Table of Contents
