Connections And Settings; Other - Sanyo DSR-M800 Instruction Manual

e_dsr_m800.book Page 38 Friday, January 31, 2003 5:45 PM
6 RS-485/NETWORK SET
When connecting the digital video recorder to a network,
check the IP address with the network administrator.
Up to 250 digital video recorders can be connected with
manually-set IP addresses. To connect more digital video
recorders, you must use automatic IP address settings.
The set IP address is displayed in the <NETWORK SET>
screen.
RS-485 connections and settings
Connect the digital video recorder's RS-485 (A, B) control
terminals in series to the system controller, hard disk digital
recorder or similar device.
RS485 REMOTE
A B C C
[MENU] button [
SEARCH
MENU REVIEW
MENU RESET
[ ] button
1
Press the [MENU] button.
The [MENU] button lights, and the <MAIN MENU> screen
appears.
2
Select "6. RS-485/NETWORK SET", and
press the [
The <NETWORK SET> screen appears.
ALARM IN
ALARM RESET
CLOCK NON
ADJ REC OUT ALARM OUT
WARNING OUT
FULL OUT
IN OUT C C
] button [ ] button
PLAY/
STOP
CUE EXIT/OSD
STILL
[EXIT/OSD] button
] button.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
[Settings] ( indicates default setting.)
Item Setting
DVR NAME Display When remote operations software (sold
(1) only separately) is in use, displays the name of
the digital video recorder set in the PC.
IP ADDRESS Display Displays the set address number.
(2)
only
REMOTE AS VCR When the digital video recorder is operated
from a controller, sets it to operate as a
VCR.
(3)
DVR When the digital video recorder is operated
from a controller, sets it to operate as a
digital video recorder.
DATA SPEED Used to select the communication
(4)
speed.Selections: 19200/2400/4800/9600
STATUS INFO ON Enables status information to be sent on the
RS-485 line.
(5)
OFF Not set
ALARM INFO ON Enables alarm information to be sent on the
RS-485 line.
(6)
OFF Not set
ADDRESS* Display Displays a number between 0 and 127,
only based on the IP address set by the dip
(7) switches. When connecting multiple
recorders, each must have a unique
address.
* Values above 127 can be set as the IP address on the
dip switches (a setting of 0 or above 250 is read as 250),
but only the least significant 7 bits (a value between 0
and 127) are read as the RS-485 address.
3
Press the [ ] and [
the desired item, then press the [
button.
4
Press the [ ] and [
change the setting, then press the
[ ] button.
5
Use the same procedure to set the other
items as needed.
6
When you have finished making the
settings, press the [EXIT/OSD] button.
The display returns to the normal screen.
Description
] buttons to select
]
] buttons to
38