Installing Memory Modules - HP ProOne 600 Hardware Reference Manual
Hp proone 600 g4 21.5-inch all-in-one business pc
hp proone 400 g4 23.8-inch all-in-one business pc
hp proone 400 g4 20-inch all-in-one business pc
Hide thumbs
Also See for ProOne 600:
- Illustrated parts & service map (4 pages) ,
- Hardware reference manual (59 pages) ,
- Hardware reference manual (49 pages)
Table of Contents
Advertisement
Installing memory modules
There are two memory slots on the system board. To remove or install memory modules:
1.
To locate the memory modules on the system board, see
2.
To remove a memory module, press outward on the two latches on each side of the memory module (1),
then pull the memory module out of the slot (2).
3.
Slide the new memory module into the slot at approximately a 30° angle (1), then press the memory
module down (2) so that the latches lock it in place.
NOTE:
on the memory slot.
4.
Turn on the computer. The computer automatically recognizes the additional memory when you turn on
the computer.
A memory module can be installed in only one way. Match the notch on the module with the tab
Locating internal components on page
Removing and installing memory
23.
25
Advertisement
Table of Contents
