Installing The Optical Disc Drive - HP ProOne 600 Hardware Reference Manual
Hp proone 600 g4 21.5-inch all-in-one business pc
hp proone 400 g4 23.8-inch all-in-one business pc
hp proone 400 g4 20-inch all-in-one business pc
Hide thumbs
Also See for ProOne 600:
- Illustrated parts & service map (4 pages) ,
- Hardware reference manual (59 pages) ,
- Hardware reference manual (49 pages)
Table of Contents
Advertisement
3.
Connect the power and data cables to the hard drive (1).
4.
Align the hard drive and slide it toward the edge of the computer until the hard drive snaps into place (1),
and then secure it with a screw (2).
Installing the optical disc drive
The optical disc drive is located above the system components. To locate the optical disc drive on the system
board, see
Locating internal components on page
Remove the blank covering the optical disc drive connector (1) and slide the optical disc drive enclosure
▲
into place (2). Optionally, secure it with two screws for stability (3).
NOTE:
28
Chapter 3 Hardware repair and upgrade
The optical disc drive can be installed in only one way.
23.
Advertisement
Table of Contents
