Omron CJ Series Connection Manual page 10

5．Applicable Devices and Device Configuration
Precautions for Correct Use
Update CX-Programmer and Network Configurator to the versions specified in this Clause
5.2. or to higher versions. If you use a version higher than the one specified, the procedures
and related screenshots described in Section 7. and subsequent sections may not be
applicable. In that case, use the equivalent procedures described in this document by
referring the CX-Programmer OPERATION MANUAL (Cat. No. W446) and Network
Configurator Online Help.
Precautions for Correct Use
Update Sysmac Studio to the version specified in this Clause 5.2. or to a higher version.
If you use a version higher than the one specified, the procedures and related screenshots
described in Section 7. and subsequent sections may not be applicable. In that case, use the
equivalent procedures described in this document by referring to the Sysmac Studio Version
1 Operation Manual (Cat. No. W504).
Additional Information
For specifications of 24 VDC power supply available for Switching hub, refer to the Switching
Hub W4S1-series Users Manual (Cat. No. 0969584-7).
Additional Information
For specifications of 24 VDC power supply (unit power supply and the I/O power supply),
TM
refer to the NX-series EtherNet/IP Coupler Unit User's Manual (Cat. No. W536).
Additional Information
The system configuration in this document uses USB for the connection between Personal
computer and PLC. For information on how to install the USB driver, refer to A-5 Installing the
USB Driver of the CJ-series CJ2 CPU Unit Hardware User's Manual (Cat. No. W472).
Additional Information
The system configuration in this document uses USB for the connection between Personal
computer and Coupler Unit. For information on how to install the USB driver, refer to A-1
Driver Installation for Direct USB Cable Connection in Appendices of the Sysmac Studio
Version 1 Operation Manual (Cat. No. W504).
7