Reading, Writing And Deleting Messages; Sending Text Messages - Multitech MultiConnect MicroCell MTCM-LAT3 User Manual

CONFIGURING AND COMMUNICATING WITH YOUR DEVICE
The file is received through the device. The device responds with:
NO CARRIER
The data connection closes automatically when the file sending ends.
Closing the FTP Data Connection
After the file is sent:
1. Close the FTP connection.
Enter:
AT#FTPCLOSE
2. Close the PPP data connection.
Enter:
AT#SGACT=1,0
The device responds with OK.

Reading, Writing and Deleting Messages

Sending Text Messages

To send a text message in text mode:
1. Check signal strength.
Enter:
AT+CSQ
2. Verify device is registered on the cellular network.
Enter:
AT+CEREG?
Should return:
+CEREG: 0,1 or +CEREG: 0,5
OK
3. Put the device in text mode.
Enter:
AT+CMGF=1
The device responds.
OK
4. Enter the recipient's number and your message.
Enter:
AT+CMGS="##########"
>Your message here
where ########## is the recipient's number.
5. Send the message.
Enter CTRL+Z.
The device responds:
+CMGS: #
OK
26
®
MultiConnect MicroCell MTCM-LAT3 and -LSP3 User Guide