Installation; Scope Of Delivery; Basics Of The Installation; Requirements Of The Measurement Location - wtw DIQ/S 182 Operating Manual

System 182
ba75499e09 12/2014
3

Installation

3.1

Scope of delivery

The following parts are included in the scope of delivery of the
DIQ/S 182:
 DIQ/S 182 Universal Transmitter
 Accessory kit with:
– Contact carrier with screws
– ISO cap nuts with screws and ring washers
– Cable glands with sealing gaskets
 Operating manual.
3.2

Basics of the installation

3.2.1 Requirements of the measurement location

The measurement location must meet the environmental conditions
specified in section 9.1 DIQ/S 182.

3.2.2 Additional MIQ power supply modules

The power pack of the Universal Transmitter supplies enough power
for most combinations of sensors. Some sensors with high power
consumption may require the installation of an MIQ power supply
module in addition to the Universal Transmitter. For installation, refer to
the operating manual of the power supply module. The table on the
following page shows which sensor/sensor combinations require an
additional power supply module.
NOTE
The terminator switch on the terminal strip of all additional MIQ
modules in the system 182 must be set to "Off".
Installation
3 - 1