Setting Of 'Swdip - LG PRVC0 Installation Manual

6. Setting of 'SWDIP'

■ Using 'SWDIP', select the option of control function as
described below
ON
L1 2 3 4
Notes
Default status is L1 : ON
L2 : OFF
• Output signal setting
Position
ON
L1 2 3 4
ON
L1 2 3 4
ON
L1 2 3 4
ON
L1 2 3 4
• RS-485 communication function setting
Position
ON
L1 2 3 4
ON
L1 2 3 4
Notes
After change 'SWDIP' setting, then you must press reset switch to reflect the setting.
Before operating the outdoor unit, check the flow rate of water and voltage signal of PCB.
Minimum flow rate of water is recommended 40% of rated flow rate. Otherwise, the outdoor unit get
damage.
Control signal : DC 0V(OFF), DC 8~10V(ON)
Control signal : DC 0V(OFF), DC 6~10V(ON)
Control signal : DC 0V(OFF), DC 4~10V(ON)
Default status
Control signal : DC 0V(OFF), DC 2~10V(ON)
RS-485 communication function enable
RS-485 communication function disable
Setting and using method
Function
Function
Installation manual 17