Table of Contents
Advertisement
off alternately. When in use the internal backlighting will illuminate the controls .
4.2 Overhead Dome Lights
The lights integrated into the BAT are controlled by Push-Button switch. Push-Button
switch to the protrusion position will turn the lights off. And other position will allow the
lights to turn on.
4.3 Remote Sensor
The BAT incorporates
to allow the unit to be controlled simply by pointing its remote control at the remote
sensor eye.
4.4 DVD Basics
To get the optimum use out of the DVD section, make sure you read this section
completely.
5. Remote Control Operation
Battery Installation
Before attempting to operate your Remote Control, install the batteries as described below.
1) Turn the Remote Control face down. Using a clip and fingertip, pull down the battery
cover open.
2) Install One "CR2025" batteries as shown. Make sure that proper polarity (+ or -) is
observed.
3) Align the cover tabs with the remote control and press down until the cover clicks.
If remote doesn't operate properly
three Infrared
sensors which relay signals from the remote control
Advertisement
Table of Contents
