Removing The Printed Pieces - Olivetti 3D DESK User Manual

NOTE: During printing suspension, and due to the high temperature of the nozzle, the material may continue
to flow causing the printed piece to become distorted.
To cancel a printing job, access the menu, using the jog dialer select Stop Printing, then confirm by pressing the
jog dialer.
Printing is cancelled.
Note that the extruder assembly will remain stopped at the last position assumed before printing was cancelled.
You must therefore either move the extruder manually using the menu commands or execute a homing
procedure.

Removing the printed pieces

Once printing is terminated, remove the printed part using the spatula provided.
It's advisable to remove the printing bed to make the piece removal easier and safer. To do this, follow these
steps:
•
lower the plate, using the following sequence: press the jog dialer, rotate counterclockwise and select
"Prepare"; rotate counterclockwise and select "Move axis"; rotate counterclockwise and select "Move 1
mm". Turn back counterclockwise and select "Move Z". Rotate counterclockwise until it reaches a value of
approximately +100, then press the jog dialer to confirm your choice
•
when the printing bed has finished moving, remove the four clips, pressing lightly on the metal fins.
•
remove the glass plate
•
remove the printed piece from the plate with the spatula, exercising pressure on different sides of the
piece.
As the piece could be stuck to the printing table quite firmly, work slowly and carefully to avoid damaging it.
•
at the end, replace the plate and block it with the 4 clips
CAREFUL NOT TO TURN THE PLATE (ON THE BOTTOM AND 'THIS ONE FILM FROM SAFETY DO NOT
REMOVE)
3-6
Manuale d'uso
386446U-01