Chapter 2 - Printer Preparation; Preparing The Printer; Unblocking The Extruder Assembly; Powering On The Printer - Olivetti 3D DESK User Manual

Chapter 2 – printer Preparation

PREPARING THE PRINTER

This chapter describes the procedures that must be followed to configure the Olivetti 3D DESK printer correctly
and set it up properly for the following printing phases.

Unblocking the extruder assembly

To protect the printer during shipment, the printing carriage is blocked into position using one band.
So before starting to print you must remove this band.

Powering on the printer

Connect the printer to a 220V power supply using the cord provided and switch it on at the power switch.

LCD Display

When the printer is powered on, the LCD display illuminates.
On the display you can see the main printer status information.
Figure 2-1 LCD display for Rest mode
Manuale d'uso
386446U-01 2-1