Gcode Printing; Overhang And Generating Supports - Olivetti 3D DESK User Manual

GCODE printing

To continue with printing your GCODE, proceed as explained in the paragraph on printing the test piece, that
is:
1. Insert the SD CARD supplied in the package into the slot on the printer front
2. Select the SD Card menu to access the file manager.
3. Select the file to print by turning the jog dialer then press to confirm
4. The machine now starts the automatic printing procedure reading the GCODE indicated and executing all
the phases. You can follow the process from the Info menu or, of course, observing it through the
transparent glass of the machine.

Overhang and generating supports

Portions of a model that cannot be printed using the FFF printing process without adequate supports
underneath are defined as overhang.
As in FFF technology layers are deposited one on top of the other, each layer must have underneath an
adequate support base.
If your 3D model has planes or surfaces that rise upwards with an inclination of over about 50° with respect to
the vertical (40° from the table), the layer deposited may not have sufficient support underneath and may
collapse downwards, compromising the printing quality.
To avoid the overhang problem, and when required, the slicing software can automatically generate material
supports (based on parameters that can be set by the user).
This additional material must therefore be removed manually at the end of printing process.
3-4
Manuale d'uso
386446U-01