Adjust The Angle Of The Coil - Minelab CTX 3030 Manual

Adjust the Angle of the Coil

1. Loosen the bolt that connects the lower
shaft to the coil. It should be loose
enough to allow the coil to be moved for
adjustment, but tight enough that the
coil can hold its position.
2. While holding the detector as if detecting,
lightly press the coil to the ground until it
sits flat/parallel with the ground. The coil
should remain parallel when lifting to the
sweep height, approximately 25mm (1")
above the ground.
3. Tighten the bolt, taking care not over-
tighten it.
9