Remove The Battery Pack From The Battery Compartment; Recharge The Li-Ion Battery Pack With The Bc 10 Battery Charger - Minelab CTX 3030 Manual

Remove the Battery Pack from the
Battery Compartment
1. Ensure that the detector is turned off
before removing the battery pack.
2. Rest the detector on a flat surface and
release the latches on both sides of the
control box.
3. Remove the battery pack from the control
box bulkhead.
Recharge the Li-Ion Battery Pack
with the BC 10 Battery Charger
1. Remove the battery pack from the
detector (x-ref ) and place it into the
charger unit, ensuring that the pins line
up.
2. Insert the plug pack cable connector into
the socket on the right hand side of the
charger unit.
3. Plug the other end of the cable into the
wall socket and turn on the switch. (see
BX 10 instruction manual?).
4. Leave the unit for 18 hours to fully
recharge.
If the battery was not completely
discharged, the charging time will be
shorter. New batteries will reach their full
11