Blower Installation (Optional); Adjusting The Blower Speed Control - Heatilator ECO CHOICE ECO-ADV-WS22 Owner's Manual

B. Blower Installation (Optional)
1. Align holes in mounting flange of blower with bolt holes
in appliance. Blower should be positioned at bottom of
rear outer skin as shown in Figure 39.1.
2. Insert and tighten bolts supplied with the kit, securing
blower onto outer wall of appliance.
3. Place the bracket containing the snap disc and magnet
under the bottom left rear corner as shown in Figure
37.1.
See pages 14 and 21 for detailed operating instructions for
the blower and snap disc.
CAUTION
Shock Risk.
• Do NOT remove grounding prong from plug.
• Route cord away from appliance.
• Do NOT route cord under or in front of
appliance.
• Plug directly into properly grounded 3 prong
receptacle.
Figure 37.1
www.heatilatorecochoice.com
C. Adjusting the Blower Speed Control
The blower speed control for this appliance is adjusted
at the factory, and normally does not require further
adjustment.
Snap Disc Bracket
with Magnet
7057-128K • October 24, 2018
NOTE: When the speed control is turned clockwise, it
will click on to high speed. Continue to turn the
speed control clockwise to decrease the speed.
At full clockwise, the blower should blow gently,
but should not stop.
Blower
MANUAL: Over-rides the
Snap Disc
AUTO: Fan will turn ON/OFF
Automatically by the Snap Disc
Controls the Fan Speed
ECO-ADV-WS22
Snap Disc
37