Snap Disc Replacement; Door Handle Assembly - Heatilator ECO CHOICE ECO-ADV-WS22 Owner's Manual

ECO-ADV-WS22
C. Snap Disc Replacement
1. Disconnect power supply. Locate the snap disc bracket
assembly at the bottom left rear corner of the appliance
(Figure 24.1).
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the
snap disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 24.2.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Snap Disc Location
Figure 24.1
Snap Disc
Magnet
Figure 24.2
24
D. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Add up to three washer as shown in Figure 24.3 on the
inside of the door.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not over tighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod (Figure 24.3).
Do not over tighten lock nut. The door handle needs to
move smoothly.
Locknut
Figure 24.3
Spade
Connectors
7057-128K • October 24, 2018
CAUTION
Door Cross
Latch Cam
Section
3/8 inch
Spacing
Add up to 3
Washers
washers on
this side of
the door
www.heatilatorecochoice.com
Spring
Handle
Door Handle
Shaft
Square Key