Door Handle Assembly; Blower Installation (Optional) - Heatilator ECO CHOICE WS18-AU Owner's Manual

B. Door Handle Assembly
Install spring handle using a counter-clockwise motion until
the spring handle has a 51mm clearance from bend of
door hand rod (Figure 39.1).
51mm clearance is
required from bend in
door handle rod to
end of spring handle
Door handle
Figure 39.1
Figure 39.1
www.heatilator.com
C. Blower Installation (Optional)
1. Align holes in mounting flange of blower with bolt holes
2. Insert and tighten bolts supplied with the kit, securing
3. Place the bracket containing the snap disc and magnet
See pages 14 and 21 for detailed operating instructions for
the blower and snap disc.
Spring
handle
Snap Disc Bracket
with Magnet
7056-153F • 20 August, 2018
in appliance. Blower should be positioned at bottom of
rear outer skin as shown in Figure 39.2.
blower onto outer wall of appliance.
under the bottom left rear corner as shown in Figure
39.2.
CAUTION
Shock Risk.
• Do NOT remove grounding prong from plug.
• Route cord away from appliance.
• Do NOT route cord under or in front of
appliance.
• Plug directly into properly grounded 3 prong
receptacle.
Blower
Snap Disc
MANUAL: Over-rides the
Snap Disc
AUTO: Fan will turn ON/OFF
Automatically by the Snap Disc
Controls the Fan Speed
Heatilator EcoChoice WS18
39