Event Log And Setting File When Recording Is In Progress - YOKOGAWA GX10 User Manual

1.5 Audit Trail Function
1.5.5 Event Log and Setting File When Recording Is in Progress
1-26
The setting changes are recorded in the event log. You can configure the GX/GP to
automatically write into the measured data a message indicating that the settings have
changed. The GX/GP does not save a setting file.
For the setting procedure, see section 1.10.4, "Setting Trend Display Conditions," in the
User's Manual.
Logged Operations (Settings that can be changed during recording)
The following setting changes can be logged during recording.
However, the following limitations apply.
• The maximum number of settings that can be changed simultaneously is 100.
If this limit is exceeded, the setting changes cannot be saved.
If this limit is exceeded, you can either cancel the setting changes or stop recording to
apply the setting changes. Save the setting changes before the number of changed
settings exceeds 100.
• You cannot set multiple consecutive channels. (Only the first channel will be selected.)
Setup Item
Alarm settings
Calibration correction
Data save settings
Communication (Ethernet) settings
User settings
Calibration reminder settings
1 When the mode is set to correction factor.
2 To use the correction factor, the aerospace heat treatment (/AH option) must be installed in the
GX/GP.
On/Off
Type
Value
Hysteresis
Logging
Output type
Output No.
Alarm delay
Mode: Linearizer Approximation/Linearizer/
Correction factor
Number of set points
Input value (1 to 12)
Output value (1 to 12)
Uncorrected value (1 to 12)
Instrument correction factor (1 to 12)
Sensor correction factor (1 to 12)
Save directory
Recipient 1
Recipient 2
Sender
Subject
User level
Mode
User name
User ID
Password
Password expiration
User property On/Off
Authority number
Sign in property On/Off
Authority of sign in
2
On/Off
Due date
Daily reminder
Re-notification cycle
Buzzer
Calibration correction setting
Title
Notification message 1
Notification message 2
2
1, 2
1, 2
1, 2
IM 04L51B01-05EN