Login Function; Logging In And Out Using Touch Operation; Logging In And Out Through Communication - YOKOGAWA GX10 User Manual

1.3

Login Function

1.3.1

Logging In and Out Using Touch Operation

1.3.2

Logging In and Out through Communication

IM 04L51B01-05EN
You can allow only registered users to use the GX/GP.
For the setting procedure, section 2.2.
For operating instructions, section 2.3.
You need to enter user identification information (a user name, user ID (when in use), and
password) to log in to the GX/GP in the following cases.
GX/GP Access Method
Touch operation
Power on
Logged out condition
Login Logout
operation operation
Operation mode
1
1 This is the normal mode in which configuration and operation are performed.
Auto Logout
You can set the GX/GP to log a user out automatically when there is no touch operation over
a specified period.
In the case of general communication using Ethernet, use the timeout function.
See section 1.21.7, "Configuring the Server Function" in the User's Manual.
In the case of general communication using serial communication, use the logout function.
See section 1.22.1, "Setting Basic Communication Conditions" in the User's Manual.
Operations Available While Logged Out
You can configure the GX/GP so that when you are logged out, in addition to just being able
to log in, you can switch the screen using the Browse tab of the menu screen or from the
favorite screen list.
You need to log in as a registered user in the following cases.
For details about logging in through communication, see the Communication Command
Manual.
GX/GP Access Function Accessed
Method
Ethernet Setting and
measurement server
(General communication)
Web application
Serial Setting and
measurement function
(General communication)
Login Necessary
When the power is turned on
When logging in after logging out.
Auto logout
Login
To send commands, you need to log in by entering user
identification information (a user name, user ID (when
in use), and password). There is a special command for
logging out.
To monitor the GX/GP, you need to log in by entering
user identification information (a user name and
password). Only Monitor level users can log in. To log
out, close the Web page.
To send commands, you need to log in by entering user
identification information (a user name, user ID (when
in use), and password). There is a special command for
logging out.
1
2
3
App
1-17