I/O Side; Jumpers - Winmate FA30-210 User Manual

USER MANUAL

2.1.3 I/O Side

2.2.1 Jumpers

This section explains how to set jumpers for correct configuration of the
motherboard. A metal-bridge jumper used to close an electric circuit, and it usually
consists of two metal pins and one small clip protected by a plastic cover that
slides over the pins to connect them. Users can connect the pins with the clip to
close a jumper, and remove the clip to open a jumper. Generally, a jumper will
NOTE:
A pair of needle nose pliers may be helpful when working with
jumpers. If you have any doubts about the best hardware
configuration for your application, contact your local distributor or
sales representative before you make any changes. Generally, you
simply need a standard cable to make most connections.
have three pins which labeled 1, 2, and 3.
The jumper setting diagram is shown below. When the jumper cap is placed on
both pins, the jumper is SHORT. The illustration below shows a 3-pin jumper; pins
1 and 2 are short. If you remove the jumper cap, the jumper is OPEN.
CHAPTER 2
1
PIN 1-2 SHORT
2
3
- 16 -
HARDWARE INSTALLATION