Signal Routing From The Monitoring Panel To The Prediction Panel - Emerson AMS 6500 Reference Manual

Table 6-5: Terminal descriptors for MSIG 2
J5
SIG+13/+24 V
SIG-13/+24 V return
CH13 -24 V
Gnd (-24 V return)
Shield
SIG+14/+24 V
SIG-14/+24 V return
CH14 -24 V
Gnd (-24 V return)
Shield
SIG+15/+24 V
SIG-15/+24 V return
CH15 -24 V
Gnd (-24 V return)
Shield
SIG+16/+24 V
SIG-16/+24 V return
CH16 -24 V
Gnd (-24 V return)
Shield
6.4 Signal routing from the monitoring panel to
the prediction panel
You can set DIP switches on the A6500-M-RTRM termination panel to route sensor and
tachometer signals from the A6500-P-RTRM termination panel. Set these switches to the
ON position to connect to their respective A6500-P-RTRM buffered outputs. See
Rear termination panel
The external input connectors on the A6500-M-RTRM are connected to the 12-2-2 module
signal inputs, regardless of whether the DIP switches are set to ON or OFF. Therefore, if a
DIP switch is set to route an input from the A6500-P-RTRM, do not connect an external
sensor to the associated external input of the A6500-M-RTRM. Set the DIP switches for
accelerometer power to OFF while routing inputs from the A6500-P-RTRM.
MHM-97125-PBF-EN, R0
J6
SIG+17/+24 V
SIG-17/+24 V return
CH17 -24 V
Gnd (-24 V return)
Shield
SIG+18/+24 V
SIG-18/+24 V return
CH18 -24 V
Gnd (-24 V return)
Shield
SIG+19/+24 V
SIG-19/+24 V return
CH19 -24 V
Gnd (-24 V return)
Shield
SIG+20/+24 V
SIG-20/+24 V return
CH20 -24 V
Gnd (-24 V return)
Shield
for DIP switch locations.
J7
SIG+21/+24 V
SIG-21/+24 V return
CH21 -24 V
Gnd (-24 V return)
Shield
SIG+22/+24 V
SIG-22/+24 V return
CH22 -24 V
Gnd (-24 V return)
Shield
SIG+23/+24 V
SIG-23/+24 V return
CH23 -24 V
Gnd (-24 V return)
Shield
SIG+24/+24 V
SIG-24/+24 V return
CH24 -24 V
Gnd (-24 V return)
Shield
Wire terminations
J8
Tach+3
Tach-3
TACH3 -24 V
Gnd (-24 V return)
Shield
Tach+4
Tach-4
TACH4 -24 V
Gnd (-24 V return)
Shield
I/O+3
I/O-3
I/O3 -24 V
Gnd (-24 V return)
Shield
I/O+4
I/O-4
I/O4 -24 V
Gnd (-24 V return)
Shield
43