Centurion SD04 Installation Manual page 51

9.2.2. Light Function / Remote Learning.
Learning a button to Function Two will enable that button to switch the courtesy light
on and off, or learn in additional remotes.
Operation
• First Operation:
Momentarily press the associated remote control button to either switch the courtesy
light on or off. If the light has been switched on, it will time out as per the maximum
current timer of 2 minutes.
• Second Operation:
Press and Hold the associated remote control button to enter Remote Learn Mode.
Refer Section 10.1
Learning procedure
Enter Learn mode (Refer 10.1). Using the '+' and '-' buttons, select 'li'. Press and hold
the transmitter button until the display flashes 'li' and the buzzer beeps twice.
9.2.3. Holiday Lockout Function
Electronically lock the controller for use. In other words, no transmitters or inputs, other
than those learned for Holiday Lockout Mode, will be able to trigger the operator.
Operation
To engage Holiday Lockout Mode, the button learned to engage this function must be
pressed for three seconds before Holiday Lockout Mode will engage. The courtesy
light will emit a single flash and the onboard buzzer, a single beep.
When the door reaches the closed position, the courtesy light will remain ON, and time
out as per normal. Should a button which operates a function other than any of
those associated with Holiday Lockout Mode be pressed whilst the operator is locked,
the onboard buzzer will emit a single beep and the courtesy light will triple flash.
To disengage Holiday Lockout, press any button on any transmitter that has been learned
for Holiday Lockout, and will emit a double beep, and two flashed to indicate it has been
disabled.
Learning procedure
Enter Learn mode (Refer 10.1). Using the '+' and '-' buttons, select 'ho'. Press and hold
the transmitter button until the display flashes 'ho' and buzzer beeps three times.
9.2.4. Autoclose Override Function
This function will allow the associated button to override the Autoclose function if
it has been selected, resulting in the door staying open.
Operation
• With the door in the closed position, the Autoclose Override button must be pressed
and held for at least three seconds to engage / activate this function. The light will
flash quickly a number of times and simultaneously the buzzer will emit multiple
beeps to confirm the operation of this function
• The door will also operate to open and stay open without Autoclosing
• Pressing the open / close button will trigger the door to close
www.centsys.com page 51