Centurion SD04 Installation Manual page 24

Use a spirit level to ensure that
the SDO4 is still level and parallel
to the ceiling. Align the holes of
the punched angle iron mounted
to the ceiling, with the holes on
the punched angle iron mounted
to the drive rail hanger. Secure it
into position using two supplied M8
flange bolts and nuts using a 13mm
socket.
Using a spirit level, ensure
that the SDO4 is level on
both the X-Axis and Z-Axis
of the horizontal plain.
If it is not, it may cause the
motor to stress, or the drive
rail to twist.
RECOMMENDED
FIGURE 34. CORRECT AND INCORRECT MOUNTING CONFIGURATIONS FOR THE SDO4
M8 Flange bolts
Spirit level
SDO4
NOT RECOMMENDED
page 24
Punched
angle iron
mounted
to ceiling
M8 Flange
nuts
Punched
angle iron
FIGURE 32
SDO4
FIGURE 33
www.centsys.com