SmartLogger2000
User Manual
2.
3.
Step 3 Put the tapping screws through the SmartLogger mounting ears and washers into the
mounting holes in the wall.
When the SmartLogger is wall-mounted, ensure that the cable connection area faces
downwards for ease of cable connection and maintenance.
Step 4 Tighten the tapping screws using a torque screwdriver.
Figure 3-7 Tightening the tapping screws
----End
3.5.2 Installing a SmartLogger Along a Guide Rail
Context
Huawei does not provide the SmartLogger guide rail. If you choose this installation mode,
prepare a 35 mm standard guide rail by yourself.
Issue 04 (2018-04-10)
To prevent dust inhalation or contact with eyes, the operator should wear an anti-dust
respirator and safety goggles when drilling holes.
Clean up any dust in and around the holes using a vacuum cleaner and measure the hole
distance. If the holes are inaccurately positioned, drill holes again.
Slightly tighten the expansion sleeves, vertically insert them into holes, and knock them
completely into the holes by using a rubber mallet.
Drive the tapping screws into the expansion sleeves, and reserve 10 mm outside of the
holes.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Device Installation
39