Electrolux EXI09HJIW User Manual page 7

4.2 Location of the Remote Control
Fig.01
Max. 8m
4.3 Battery installation/replacement
Fig.02
Keep the remote control where its
signal can reach the receiver of the
indoor unit (a maximum distance of
When you select the timer operation,
the remote control automatically
transmits a signal to the indoor unit at
If you keep the remote control in a
position that hinders proper signal
transmission, a time lag of up to
15 minutes may occur.
When the remote control sends out
a signal, the symbol
for about 1 second on the display.
The indoor unit will acknowledge the
signal with a beep when it receives an
effective signal.
Slide the battery compartment cover
off and insert two new alkaline dry
correctly.
Slide the battery compartment cover
back on.
not use old or varied ones,
otherwise, it may cause
problems with the remote
control.
for a long time, remove the
batteries as old batteries may
leak or corrode and damage
the remote control.
use is about six months.
not operate normally, please
abnormal operation continues,
replace with new batteries.
ENGLISH 7
will blink