Recorder Status And Error Page - ABB C1300 User Manual

C1300
Advanced circular chart recorder

1.2.1 Recorder Status and Error Page

If any of the start-up self-tests (see Fig. 1.3) fail, the error message 'Fail' is displayed. Refer to Fig. 1.4 for possible cause and remedial
action information.
Component
Module in position 2
Module in position 3
Module in position 4
Module in position 5
Module in position 6
Main Board
Software Key
Note. The software key is optional hardware that is fitted to enable optional software features – Totalizers, Math
Blocks, System Clock and Timers.
Acknowledging Errors
Note. Acknowledging an Error Message clears the error state but does not rectify the fault. After acknowledging an
error, carry out the appropriate action detailed in the above table.
Fig. 1.4 Start-up Error Messages
IM/C1300 Rev. J
Main Board CPU and Configuration Test Results
Software Key (see
Module Identification and Test Results
Possible Cause
Analog input and/or analog output calibration is corrupt.
Configuration stored in non-volatilememory is corrupt.
below) Identification and Test Result
Note
Action
Check and correct program data.
If the fault persists, contact the Company.
Power down and then up again.
If the fault persists, contact the Company.
1 Preparation
5