Input (Pen) Channel Display - Separate - ABB C1300 User Manual

C1300
Advanced circular chart recorder
2.3.3 Input (Pen) Channel Display – Separate
The following screens are displayed only if Pen Ch Display is set to Separate – see Section 3.4, page 20.
10
Input Channel 1 (Pen 1)
Channel tag.
Measured value.
Alarm icons and measured value units.
Note. If Pen 1 Source is set to None (Section 3.14), only a measured value of 0 is displayed.
Input Channel 2 (Pen 2)
Note. If Pen 2 Source is set to None (Section 3.14), only a measured value of 0 is displayed.
Totalizer, Math or Timers software options not enabled by installation of the appropriate software
key and optional Data Logging hardware not installed – return to top of page.
Totalizer software option enabled by installation of the appropriate software key and Totals
Display not set to Off (Section 3.4) – see Sections 2.3.6 to 2.3.10.
Optional Data Logging hardware installed – see Section 2.3.11, page 15.
Optional Data Logging hardware not installed and Totalizer software option enabled by
installation of the appropriate software key and Totals Display set to Off (Section 3.4) –
continued below.
System Time/Date Display
Notes.

Available only if any one of the Totalizer, Math or Timers software options are enabled by
installation of the appropriate software key, or the optional Data Logging hardware is
installed.

If Pen Ch Display and Totals Display are set to Off (Section 3.4) and any of the above
software options are enabled and the optional Data Logging hardware is not installed, the
System Time Display is the only Operating Page screen available.
Return to top of page.
2 Operation
IM/C1300 Rev. J