Configuration; Introduction; Preparation For Configuration; Configuration Level Security - ABB C1300 User Manual

C1300
Advanced circular chart recorder

3 Configuration

3.1 Introduction

The configuration procedures are used to make changes to the operating parameter values and for scale adjustment. Configuration
of all channels is performed from faceplate 1.
The configuration settings can be backed up to a PC and restored to the recorder as required – see Section 3.16, page 58.
An overview of the Configuration Pages is on the rear cover fold-out.
When changing the input type, it may be necessary to reposition the input selector links accordingly – see Section 5.2.1, page 67.

3.2 Preparation for Configuration

Note.

Isolate any external alarm/control circuits if inadvertent operation during configuration is undesirable.

The recorder responds instantly to parameter changes. These are saved automatically when either the
pressed.
The display screen of faceplate 2 (if fitted) shows Configuration Mode when the configuration pages are accessed by

scrolling past Security Code in the Main Menu on the display screen of faceplate 1.

3.3 Configuration Level Security

Unauthorized access to the configuration pages is prevented by the use of a security code.
The security code, set to '0' when the recorder is despatched, can be set to any value from 0 to 9999 – see Configure Password in
Section 3.4 on pgae 20. When set to anything other than '0', access to all configuration menus (i.e. all menus below Security Code)
is prevented. Enter the correct code to enable access to the configuration menus.
IM/C1300 Rev. J
Security Code
Press the key to open the Main Menu.
Highlight Security Code.
Enter Security Code
Enter the correct security code.
Return to Main Menu.
3 Configuration
or key is
19