Input (Pen) Channel Display - Separate And Dual - ABB C1300 User Manual

C1300
Advanced circular chart recorder
2.3.5 Input (Pen) Channel Display – Separate and Dual
The following screens are displayed only if Pen Ch Display is set to Separate & Dual – see Section 3.4, page 20.
12
Input Channel 1 (Pen 1)
Channel tag.
Measured value.
Alarm icons and measured value units.
Note. If Pen 1 Source is set to None (Section 3.14), only a measured value of 0 is displayed.
Input Channel 2 (Pen 2)
Note. If Pen 2 Source is set to None (Section 3.14), only a measured value of 0 is displayed.
Input Channels 1 and 2 (Pens 1 and 2)
Channel tag.
Measured value and units.
Note. If Pen X Source (where X is the pen number) is set to None (Section 3.14), only a
measured value of 0 is displayed for that channel.
Totalizer, Math or Timers software options not enabled by installation of the appropriate software
key and optional Data Logging hardware not installed – return to top of page.
Totalizer software option enabled by installation of the appropriate software key and Totals
Display not set to Off (Section 3.4) – see Sections 2.3.6 to 2.3.10.
Optional Data Logging hardware installed – see Section 2.3.11, page 15.
Optional Data Logging hardware not installed and Totalizer software option enabled by
installation of the appropriate software key and Totals Display set to Off (Section 3.4) – see
Section 2.3.3, page 10.
2 Operation
IM/C1300 Rev. J