Electrical Connection (3-Wire) - Viking Range 5 Series Installation Manual

Electrical Connection (3-wire)

Note: If you have a 4-wire connection, see following section for
4-wire connection instructions.
WARNING
Electrical shock hazard.
To avoid risk or electrical shock,
personal injury or death; grounding
product to the frame of the unit may or
may not be permitted through your local codes. If
ground to the frame is not permitted then a 4
conductor power cord must be used.
See Electrical Requirements information.
Where local codes do not permit grounding through neutral, use a 4-wire power supply cord. The cord or
conduit must be secured to the range with the strain relief bracket.
The electrical connection is made at the terminal block, which is located behind the access door on the back of
the range.
1
Remove access door.
4
1
Attach line #1 (black) and line #2 (red)
leads to outside terminal. Attach neutral wire
(white) to center terminal on the terminal block.
grounded in accordance with local codes or in
absence of codes, with the National Electrical
Code (NEC). ANSI/NFPA 70-latest edition.
2
3
Remove supply cord strain relief
bracket and three supply cord mounting screws
on terminal block.
5
1 1
Push supply cord toward terminal block
to relieve strain, reattach supply cord strain
relief bracket over supply cord.
11
WARNING
Electrical shock hazard.
To avoid risk of electrical shock,
personal injury or death; verify your
appliance has been properly
3
Feed supply cord up through hole in bottom
of range back.
6
Reattach access door.